Colorado DMV CDL General Knowledge Practice Test 1
Test 1 of 5. Pick an answer for each question to see if it is right and why; your score appears at the end. You need 40 correct answers to pass, the same ratio as the real Colorado test.
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. The engine has overheated and you need to check the coolant. What is the safe procedure with a pressurized radiator cap?
Show answer
Answer A: Shut the engine off, let the system cool, protect your hands, turn the cap slowly to its first stop so pressure escapes, step back, then remove it
A hot pressurized system throws steam and boiling coolant out of the opening, so the pressure is released slowly and only after the engine has cooled.
-
2. Rust streaks are running outward from the lug nuts on one wheel. What does this most likely indicate?
Show answer
Answer C: The lug nuts may be loose
Rust trails spreading from the nuts are a classic sign that the nuts have worked loose and the wheel has been moving on the studs.
-
3. Which vehicle is most likely to be pushed around by a strong crosswind?
Show answer
Answer B: An empty van trailer
A large flat side with very little weight behind it gives the wind the most surface and the least resistance, which is the empty van trailer.
-
4. Which windshield condition should be reported during the inspection?
Show answer
Answer B: Cracks or dirt that get in the way of your view of the road
The windshield must give a clear view; damage or grime in the driver line of sight is a safety defect.
-
5. What must be true of the trailer landing gear before you move off?
Show answer
Answer B: Fully raised, with the crank handle secured and no missing or damaged parts
Landing gear left part way down can strike a railway crossing or a ramp, and a loose crank handle can swing out into a passing vehicle.
-
6. Where do you find the maximum weight a tire can safely carry?
Show answer
Answer D: Stamped on the sidewall of the tire itself
Each tire is marked with the greatest weight it can carry at a stated inflation pressure, and the load on an axle must stay within the total for its tires.
-
7. A load overhangs the rear of the trailer. What must the driver check before leaving?
Show answer
Answer D: That the overhang is marked as required, with flags or lamps as conditions demand
A projecting load has to be made visible to other drivers, with flags in daylight and lamps when lights are required, so nobody runs into what they cannot see.
-
8. What is the correct order for a basic double clutch upshift?
Show answer
Answer B: Release the accelerator and push the clutch, shift to neutral, release the clutch, let engine speed drop, push the clutch again and shift to the higher gear
Double clutching passes through neutral with the clutch released so engine speed can drop to match the next gear before it is engaged.
-
9. What do you check about the fire extinguisher during the pre-trip?
Show answer
Answer C: That it is securely mounted, charged and that you know how to operate it
An extinguisher must be held in its bracket, show a charged gauge and be understood by the driver, because a fire leaves no time to learn.
-
10. Why should the mirrors be checked repeatedly while you make a tight turn?
Show answer
Answer C: To watch the rear of the vehicle clear other vehicles and objects
In a long vehicle the rear wheels cut inside the path of the front wheels, so only the mirrors show whether the rear is clearing curbs, poles and other vehicles.
-
11. A vehicle carries placards on its front, rear and both sides. What is the main purpose of those placards?
Show answer
Answer C: To tell emergency responders and other people what hazard the cargo presents
Placards warn everyone around the vehicle, especially emergency responders, about the kind of hazard the cargo presents.
-
12. Your right wheels drop off the pavement onto a soft shoulder. What is the correct recovery?
Show answer
Answer A: Stay on the shoulder, ease off the accelerator, brake gently only once speed is down to about 20 mph, then steer back sharply and countersteer at once
Bringing speed down on the shoulder first avoids a violent sideways jolt, and countersteering the instant the tires are back on the pavement keeps the vehicle out of the next lane.
-
13. What is the purpose of an escape ramp on a mountain grade?
Show answer
Answer C: To stop a runaway vehicle without injuring the driver
Escape ramps use soft material or a steep upgrade to bring a vehicle with failed brakes to a controlled stop.
-
14. The combined working load limit of the tiedowns on a load must equal at least what share of the cargo weight?
Show answer
Answer C: One half of the cargo weight
Federal securement rules set the aggregate working load limit at no less than half the weight of the article or group of articles being held.
-
15. The only way into a customer yard forces you to back toward the right, or blind, side of the vehicle. What should you do?
Show answer
Answer D: Use a helper and get out to check the path more often than you normally would
Blind side backing is allowed but far riskier, so it calls for a spotter you can see and for repeated checks of the path on foot.
-
16. Why does a driver use pull-ups while backing into a tight space?
Show answer
Answer C: To pull forward and start the approach again when the angle is going wrong
Stopping, pulling ahead and repositioning fixes a bad angle safely, and there is nothing wrong with needing more than one attempt.
-
17. You are entering a freeway from a short ramp with a fully loaded trailer. What should you do?
Show answer
Answer A: Begin building speed early and wait for a large gap
A loaded vehicle accelerates slowly, so it needs both a running start and a much larger gap than a car would use.
-
18. Two vehicles of exactly the same length make a right turn, one gently and one very tightly. What is the effect on off-tracking?
Show answer
Answer A: Turning more sharply increases off-tracking, so the tight turn needs more room
Off-tracking depends on both the length of the vehicle and the sharpness of the turn; a tighter corner brings the rear wheels further inside the path of the front wheels.
-
19. Within what distance should high beams be lowered at night?
Show answer
Answer D: Within about 500 feet of an oncoming vehicle and within about 500 feet of a vehicle you are following
High beams blind other drivers at close range, so they are lowered at roughly the same distance whether the other vehicle is coming toward you or is ahead of you.
-
20. What frame defects are you looking for during the walkaround?
Show answer
Answer A: Cracks, bends or broken cross members
The frame carries the whole load, so cracked or bent rails and broken cross members are serious structural defects.
-
21. What are you checking on the mud flaps during the walkaround?
Show answer
Answer C: That they are securely attached, not torn and not dragging on the ground
A flap that is torn or hanging loose stops shielding following traffic from spray and stones, and a dragging flap can catch and tear away on the road.
-
22. For how long is a Colorado commercial driver license valid from the date of issuance?
Show answer
Answer C: 4 years
Colorado issues the commercial driver license for four years from the date of issuance.
-
23. Where on a tire is tread depth measured?
Show answer
Answer C: In a major tread groove, away from any tie bar or wear indicator
Depth is taken in a major groove and away from the raised tie bars and wear indicators, which would give a shallower and misleading reading.
-
24. A chain rated at 6,600 pounds is fitted with a hook rated at 4,700 pounds. What is the working load limit of that assembly?
Show answer
Answer A: 4,700 pounds, the rating of the weakest part
An assembly is only as strong as its weakest component, so hooks, binders and links all count and the lowest rating governs.
-
25. Why do cracked spring hangers or badly worn shackles matter?
Show answer
Answer A: They allow the axle to shift out of its correct position under the vehicle
Hangers and shackles hold the spring, and therefore the axle, in place, so when they fail the axle can move and the vehicle may become uncontrollable.
-
26. Before starting a trip, what must the driver confirm about the weight of the loaded vehicle?
Show answer
Answer A: That it is within the legal gross and axle limits for the route being driven
Overweight vehicles brake poorly, damage tires and suspension components, and can be put out of service at a scale, so weight is checked before the wheels turn.
-
27. You need fuel and the canopy over the pumps is low. What is the safe way to handle the clearance?
Show answer
Answer B: Stop and check the height at the entrance and at the way out before committing
Clearance can differ at the entry, under the canopy and at the exit, and a sloping approach changes the effective height, so both ends have to be checked.
-
28. What does the gross vehicle weight rating of a vehicle describe?
Show answer
Answer A: The maximum loaded weight of that single vehicle, as specified by the manufacturer
The rating is the manufacturer figure for the loaded weight of one vehicle, so it is a limit fixed in advance rather than a measurement of the load on board today.
-
29. You have stopped and a pedestrian is waiting to cross in front of your truck. Why should you not wave the person across?
Show answer
Answer C: Another driver may not stop, and your wave sends the person into danger
You cannot control what drivers in the other lanes will do, so you should not invite a pedestrian into a lane you do not command.
-
30. What condition should the fifth wheel be in before you back under a trailer?
Show answer
Answer C: Jaws open, plate greased, and the fifth wheel tilted down toward the rear
The jaws have to be open to take the kingpin, the plate must be lubricated to prevent hard steering, and the fifth wheel is tilted down at the rear so the trailer apron can ride up onto it.
-
31. After the first inspection of a trip, how often must cargo securement be checked again?
Show answer
Answer D: Every 3 hours or 150 miles or at each change of duty status, whichever happens first
The load must be re-checked at whichever of those points arrives first, so a loosening tiedown is found long before it fails.
-
32. Which clues warn you that a parked car may pull out or open a door?
Show answer
Answer A: Exhaust smoke, turned front wheels, a person in the seat
Signs of life in a parked vehicle, such as a running engine, turned wheels or an occupant, mean it may move or open a door into your path.
-
33. You are about to back across a quiet street into a driveway. Which of these is good practice before you start to move?
Show answer
Answer B: Turn on the four-way flashers and sound the horn to alert anyone nearby
Warning other road users and pedestrians before a reverse maneuver gives them the chance to stop or move clear before the vehicle starts back.
-
34. How far ahead can a driver see with low beams and with high beams?
Show answer
Answer C: About 250 feet with low beams and about 350 to 500 feet with high beams
Low beams reach roughly 250 feet and high beams roughly 350 to 500 feet, and speed at night has to stay inside the distance the lights really show.
-
35. Which vehicle condition makes hydroplaning more likely?
Show answer
Answer C: Tires that are worn or underinflated
Tread depth and correct pressure are what let a tire push water aside, so worn or soft tires lift onto the water film at lower speeds.
-
36. You are hauling livestock and the trailer is only partly full. What should be done?
Show answer
Answer A: Use false bulkheads or partitions to keep the animals bunched together
Animals that can move around shift the center of gravity, so a partial load is bunched together with partitions to limit how far the weight can move.
-
37. What is the correct way to make a right turn in a long vehicle?
Show answer
Answer D: Keep the rear of the vehicle close to the curb and swing wide only as you complete the turn
Swinging left before a right turn invites another driver to move into the gap on your right, so any extra width is taken as the turn is finished.
-
38. At the end of the day you find no defects on a property carrying vehicle. What does the federal rule require?
Show answer
Answer B: No written report is required, although the carrier may still ask for one
For property carrying vehicles the report is required only when a defect or deficiency is found or reported, although a carrier may impose a stricter policy.
-
39. What color must the clearance and side marker lamps and reflectors at the front of a trailer be?
Show answer
Answer A: Amber
Amber marks the front and the forward part of the sides of a vehicle, while red marks the rear, so another driver can tell which way the vehicle is facing.
-
40. How do you get more engine braking from an automatic transmission on a downgrade?
Show answer
Answer B: Select a lower range before starting down
Locking the transmission into a lower range keeps engine speed high enough to hold the vehicle back and spares the service brakes.
-
41. Why does a load of hanging meat in a refrigerated trailer require special care in curves?
Show answer
Answer D: The meat swings and has a high center of gravity, which makes the trailer unstable
Hanging meat is heavy, sits high and swings, so the trailer can tip in a curve or on a ramp taken at normal speed.
-
42. During a stop you find a package in the trailer leaking an unknown chemical. What should you do?
Show answer
Answer C: Keep clear, keep others away and get help without touching the package
A driver without the training and equipment does not handle a leak; the job is to protect people from the material and get qualified help to the scene.
-
43. Compared with a fully loaded one, an empty truck under hard braking will often do what?
Show answer
Answer A: Need a longer distance to stop because traction is poor
Stiff suspension and little weight over the tires reduce grip, so the wheels lock early and the vehicle can take longer to stop.
-
44. What is the purpose of blocking placed against cargo on a trailer deck?
Show answer
Answer B: To fill the space around the cargo so it cannot slide
Blocking is shaped to fit snugly against the cargo and fastened to the deck, removing the room the load would need in order to move.
-
45. Which document must be available to show that the annual inspection was carried out?
Show answer
Answer C: The inspection report or a copy of it, or a decal displayed on the vehicle
Proof of the periodic inspection travels with the vehicle, either as the report itself or as the decal fixed where an inspector can see it.
-
46. Below 40 mph, what following distance does the standard commercial rule of thumb call for?
Show answer
Answer C: One second for every 10 feet of vehicle length
The base rule allows one second of space for each 10 feet of vehicle length while speed stays under 40 mph.
-
47. How long must the record of a periodic inspection be kept?
Show answer
Answer A: Fourteen months
The periodic inspection report is retained for fourteen months from the date of the report, which covers the full twelve month cycle plus a margin.
-
48. Unless otherwise posted, what speed limit does Colorado set for vehicles in the business of hauling trash?
Show answer
Answer D: 45 mph
Colorado's published list of statutory speed limits includes 45 mph for vehicles in the business of hauling trash.
-
49. Where are the OVERSIZE LOAD signs normally carried on a vehicle moving under such a permit?
Show answer
Answer A: On the front and the rear of the vehicle
The warning signs face the traffic that meets the load and the traffic that comes up behind it, so they go on the front and the rear.
-
50. Why can an empty truck need a longer stopping distance than a loaded one?
Show answer
Answer C: An empty vehicle has less traction, so its wheels lock up more easily
Brakes and tires are designed for a loaded vehicle, and with little weight on the axles the tires grip less and lock sooner.