Colorado DMV CDL warm-up test

  • Questions50
  • Correct to pass40
  • Passing score80%
  • Minimum age18 years

10 questions. Pick an answer to see if it is right and why; you need 8 correct answers to pass.

  1. 1. What should you do with the previous driver vehicle inspection report before starting your trip?

    Show answer

    Answer B: Review it and confirm that listed defects were certified as repaired or as not needing repair

    Reviewing the last report and the carrier certification tells you whether reported defects have been corrected before you take the vehicle out.

  2. 2. What does the gross vehicle weight rating of a vehicle describe?

    Show answer

    Answer A: The maximum loaded weight of that single vehicle, as specified by the manufacturer

    The rating is the manufacturer figure for the loaded weight of one vehicle, so it is a limit fixed in advance rather than a measurement of the load on board today.

  3. 3. Which vehicle is most likely to be pushed around by a strong crosswind?

    Show answer

    Answer B: An empty van trailer

    A large flat side with very little weight behind it gives the wind the most surface and the least resistance, which is the empty van trailer.

  4. 4. The brake pedal goes to the floor in a vehicle with hydraulic brakes. What can you do to build some braking pressure?

    Show answer

    Answer B: Pump the brake pedal rapidly, which may bring back enough pressure to slow the vehicle

    Pumping can restore some hydraulic pressure; along with downshifting and the parking brake it is one of the ways to stop when the pedal fails.

  5. 5. How long must a Colorado commercial learner's permit be held before the skills test may be taken?

    Show answer

    Answer B: 14 calendar days

    Colorado requires the commercial learner's permit to be held for 14 calendar days before the skills test can be taken at an approved third-party testing facility.

  6. 6. You are hauling an open box of loose gravel. What does that load require?

    Show answer

    Answer A: A cover, so that material cannot blow off or spill onto the road

    Loose material that can be blown or spilled has to be covered so it does not come out of the body and strike traffic behind.

  7. 7. You have backed into the same loading bay every week for a year. How often should you still get out and walk to the rear before backing?

    Show answer

    Answer D: Every time, since the area can change while you are away from it

    A familiar space is no guarantee; vehicles, pallets, people and overhead obstructions appear between one visit and the next, so you check on every occasion.

  8. 8. Your right wheels drop off the pavement onto a soft shoulder. What is the correct recovery?

    Show answer

    Answer A: Stay on the shoulder, ease off the accelerator, brake gently only once speed is down to about 20 mph, then steer back sharply and countersteer at once

    Bringing speed down on the shoulder first avoids a violent sideways jolt, and countersteering the instant the tires are back on the pavement keeps the vehicle out of the next lane.

  9. 9. A vehicle carries placards on its front, rear and both sides. What is the main purpose of those placards?

    Show answer

    Answer C: To tell emergency responders and other people what hazard the cargo presents

    Placards warn everyone around the vehicle, especially emergency responders, about the kind of hazard the cargo presents.

  10. 10. How should speed and gears be handled when approaching a curve?

    Show answer

    Answer A: Slow to a safe speed and downshift before entering the curve

    Braking and shifting are completed before the curve so the vehicle is settled and can pull gently through it without upsetting the load.